1. Manuals
  2. Consumer Electronics Support
  3. Sharp Support
  4. Other Support
Support User Manuals
Question About Sharp Sharp SPC373
Outside temp not appear...

Please help find the manual for this Sharp atomic clock I am not getting outside temp readings after replacing the battery in the outside sending unit. What do I need to do?

Asked by Cheng on 01/10/2009 4  Answers

ManualsOnline posted an answer 15 years, 3 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Richard posted an answer 15 years, 2 months ago

5 I found out by pushing in the reset button in the back of clock restarted the outside temp.I used a paperclip to push in where it says reset.Make sure the channels match on transmitter plus clock,Good luck.You will have to reset time,ect.....
Was this answer helpful?

Jeff Brouse posted an answer 15 years, 1 month ago

3 Just a guess, but on the spc344 you need to take the battery out of the base unit for 30 seconds and then replace. Try that and good luck. Also, are there more than one channels for multiple sensors, if so, make sure that it is set to channel 1.
Was this answer helpful?

kermit posted an answer 14 years, 6 months ago

3 where can find a new sending unit for a sharp spc344?
Was this answer helpful?

Alan posted an answer 14 years, 11 months ago

2 HOW DO YOU RESET THE TIME ZONE
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual