AT&T A10 Universal Remote User Manual


 
4. How to manually program the remote
STEP 1. Power on the device you want to program
STEP 2. Locate the 4-digit code from the provided
code list.
STEP 3. Press and hold the mode key (TV, DVD, or AUX)
and while holding the mode key, press the ok key.
STEP 4. Release both the mode key and the OK key.
All the mode keys fl ash but the selected
mode key stays on.
STEP 5. Enter the 4-digit code from the code list. The
selected mode key light blinks for each digit
entry and remains off after the entry of the
fourth digit
STEP 6. Point the remote control at the selected device
and press the power key once. The device
should turn off if you have found the correct
4-digit code.
STEP 7. If there are multiple codes and one does not
work, repeat steps 1-5 using the next code
until you fi nd the correct one. If it still does not
work as intended, please refer to your users
manual.
TV________ DVD________ AUX________
3. How to charge the remote control
STEP 1. Place the remote control in the Base
Station.
STEP 2. Make sure that the charging points are in
full contact by seeing the charging lights
move.
NOTE: It is not necessary to charge the remote
control often, but remember to place it in
the Base Station at least one overnight
session per month if possible. Quick
charge the remote in 30 minutes or fully
charge the remote in 12 hours.
Save your codes.
5. How to use the Find Feature
STEP 1. If you have misplaced the remote
control, simply press the AT&T globe
on the Base Station (the remote control
will fl ash several keys and play a ring
tone)
STEP 2. Once you have located the remote
control, press any button to stop the
sound and fl ashing keys.
Charging Lights
AT&T U-verse Advanced series
A10 Remote Control
1. How to connect the Base Station
STEP 1. Determine where you would like to
place the Base Station.
STEP 2A. If the location is less than 3 feet from
the U-verse receiver, connect the
“square” end of the supplied USB cable
to the Base Station and the “rectangle”
end to the back of the U-verse receiver.
STEP 2B. If the location is more than 3 feet from
the U-verse receiver, connect one end
of the supplied plug-in power supply to
the Base Station and the other end to a
near by wall socket.
2. How to set the clock
STEP 1. Use the +H and the +M buttons on the
bottom of the Base Station to set the
hours and minutes of the clock.
STEP 2. With the remote control in the Base Sta-
-tion, press and hold the fi nd button which
will cause the clock to dim as desired.
Press and hold fi nd button again to make
clock brighter as desired.
Quick User Guide