Filter
Top Products
44
Speaker Level
Press the ENTER button to cycle through the Speaker Level selections for 5.1 CH speakers
as follows: Center, Left Surr, Right Surr, Subwoofer, Front Left, and Front Right. Each time
the ENTER button is pressed, each mode will change. To select a mode, press the direction
arrow
and the display will show the level at 0 dB. The level can be adjusted by using the
direction arrows and . Press the ENTER button to choose the level selection.
Speaker Delay
Press the ENTER button to cycle through the Speaker Delay selections for delay time as
follows: Center Delay and Surr Delay. Each time the ENTER button is pressed, each mode
will change. To select a mode, press the direction arrow and the display will show the
delay starting at 0 ms. The delay time can be adjusted by using the direction arrows
and
. Press the ENTER button to choose the delay time.
Dyn Range Comp (Dynamic Range Compression)
Press the ENTER button to cycle through the Dynamic Range Compression modes as
follows: Full or Off.
• Full: In order to limit the audio output, select this mode and the volume level will be
decreased by a specified level.
• Off: In this setting, the Dynamic Range Compression mode is "Off".
Prologic
Press the ENTER button to select the Prologic settings. Prologic can be set to Auto, ON, or
OFF. Use the directional arrows
and
to cycle through the selections and press the
ENTER button.
• Prologic On: In this setting, when the original audio output is 2CH, Stereo, this
mode will render the audio output as virtual 5.1CH sound. This mode only applies to
DVD and CD Audio modes.
• Prologic Off: In this setting, the Prologic mode is "Off".
Pink Noise
Press the ENTER button to select the Pink Noise settings via the directional arrows
and
. Pink Noise can be set to the following modes: Off, Left, Center, Right, Left Surr, Right
Surr, and Subwoofer. This mode confirms the proper location for each speaker and the pink
noise is audible in each speaker, and the correct location can be verified before the final
setting.