Filter
Top Products
4. Physical installation
4.7 Z-alignment of the ILite tiles
Z-alignment
It can happen that after installation some tiles are not correctly aligned in depth due to tolerances. The design of the tile fixation bolt
and tile fixation nut allows a small correction in depth. This correction is called “Z-alignment”.
AB
Image 4-18
A: Tile fixation nut, B: Tile fixation bolt with Z-alignment functionality.
The correction exists in moving the most inner corner of the tile in the LED-wall forward by adj
usting the tile fixation bolt in the
corresponding corner. The maximumallowed adjustmentis 1millimeter which corresponds withone fullturn (360°) counterclockwise
of the tile fixation bolt (seen from the rear of the tile).
1
m
m
m
a
x
Image 4-19
Maximum 1 millimeter adjustment of the most i
nner tile corner.
Necessary tools
• Small flat blade screwdriver.
• 10 mm nut driver.
How to align the ILite tiles in the Z-direction ?
1. Release the tile fixation nut of the most inner corner of the tile. Use 10 mm nut driver.
Note: It’s not necessary to remove the tile fixation nut, just loosen.
Image 4-20
34 R5976522 FIXED ILITE DISPLAY 17/11/2006