Barco R9000740 Home Theater Screen User Manual


 
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
R5975228 BARCOVISION 701 MULTIMEDIA 070597
SERVICE MODE
SERVICE MODE
9-5
9-5
V 701 MULTIMEDIA
Proj. address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Baudrate PC : 9600
Text : ON
Serial No. : 10359852
The 'Identification' screen gives in-
formation concerning :
- Projector address. To change the
address of your projector, contact
a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compat-
ible) or MAC. The baud rate of the projector must be the same as the baud rate
of the connected computer. When there is a difference, contact a qualified
service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can
be useful when calling for technical assistance.
Total Run Time
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
Highlight
'Total Run Time'
with the
control disk and press
ENTER
to
display the amount of time the pro-
jector has played since its first start
up at the factory.
ENTER
gives the selected item.
EXIT
returns to the Service mode menu.
ADJUST
returns to the Operational mode.
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
V 701 MULTIMEDIA
Proj. address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Baudrate PC : 9600
Text : ON
Serial No. : 10359852
The 'Identification' screen gives in-
formation concerning :
- Projector address. To change the
address of your projector, contact
a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compat-
ible) or MAC. The baud rate of the projector must be the same as the baud rate
of the connected computer. When there is a difference, contact a qualified
service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can
be useful when calling for technical assistance.
Total Run Time
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
Highlight
'Total Run Time'
with the
control disk and press
ENTER
to
display the amount of time the pro-
jector has played since its first start
up at the factory.
ENTER
gives the selected item.
EXIT
returns to the Service mode menu.
ADJUST
returns to the Operational mode.
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO