Filter
Top Products
11
CHAPTER 3: Installation
11
Fig. 3-3. Selecting the Proper “Y” Cable for Your Computer.
6. Unplug the computer monitor
cable from the graphics card.
Plug the monitor to the short
end (marked Monitor) of the
Projection Panel cable to the
computer monitor.
7. Plug the long end of the
Projection Panel cable (marked
for the appropriate computer)
to the computer’s video port.
8. Tighten the thumb screws on
the cable connectors to ensure
proper grounding.
Refer to Appendix A for additional
important information on how to
properly place a Projection Panel
on an overhead projector.
4. Follow the instructions in this
table to select the proper “Y”
cable for your computer:5.
Connect the 26-pin end (marked
LCD) of the “Y” cable to the
Projection Panel.
NOTE
Skip step 6 if you are
connecting to a classic-style
Macintosh.
Computer Cable Looks like
IBM or compatible 15-pin
with VGA Graphics Card
or IBM PS/2 with built-in
VGA or MCGA Graphics
IBM or Compatible 9-pin
with EGA or CGA
Graphics Card or
Classic Style Macintosh
Macintosh II Series or 15-pin
Macintsoh LC, Apple IIGS