Filter
Top Products
Bosch Security Systems
Divar | Installation Manual | Menu system EN | 5-10
>>> Disk Full Alarm Setup
• Set the percentage of used disk space at which the disk-full warning
message is displayed.
• Set the time in minutes before the disk is full at which a disk-full
alarm is generated.
• Select the number of the output relay that is activated when a disk-
full alarm is generated.
• Enable the beeper to activate it when a disk-full alarm is generated.
>> PLAYBACK SETUP
Use the Playback Setup list to block the playback of recordings from particular
cameras after a specified period of time.
• Choose from No Block, 1 to 7 days, 14 days, 21 days, 28 days or 31 days.
When the specified time has elapsed, the recordings of that camera from
before that time cannot be played back.
>> EVENT SETUP
Use the Event Setup menu to specify the display behavior for an input, detected
motion or video loss.
• Set the Alarm Dwell Time to select the period during which the output
relay and the beeper remain active after activation.
• Set the Trigger Dwell Time to select the period during which the
triggered view mode is displayed after activation.
•The value Follows activates the beeper and relay or view, only as long as
the event is present.
>>> Input Setup
• To restore the default input settings select the Clear Input Settings
item.
• Select the Display Monitor submenu to choose the view mode and
cameras to be displayed when an input is activated.
• Select the number of the output relay to be activated when any
alarm input is activated.
• Enable the beeper to activate it when an alarm input is activated.
• Select the Input Name submenu to assign a name to each of the 16
Divar inputs.
• If an alarm panel is connected to the RS232 port and enabled,
select the Alarm Input Mapping submenu to associate alarms from
the alarm panel with the 16 Divar inputs.
• Select the Auto-protect submenu to choose automatic protection of
video clips activated by a specified input.
Display mon A
• Select the input number (1 to 16) for which you wish to set the view
mode.
• If you have controllable cameras, set a camera number and a pre-
position number. The specified camera goes to this position when
the numbered input is activated.
• Select a view mode. Only view modes that are enabled can be
selected.
• If you have selected the full-screen or quad view mode, select the
cameras to be displayed.
Display mon B
• Select the input number (1 to 16) for which you wish to set the view
mode.
• If you have controllable cameras, set a camera number and a pre-
position number. The specified camera goes to this position when
the numbered input is activated.
• Select up to four cameras to be displayed in sequence.
Alarm Input Mapping
• Only shown if alarm panel is connected and enabled.
• The control console type is displayed.
• For each of the 16 alarm inputs, select either the physical Divar
input (the physical input is automattically mapped to its
corresponding alarm input number) or an input from the control
console (Alarm Panel 1 to Alarm Panel 238).