Filter
Top Products
Basic Operations
25
MAX675VDII
English
Owner’s manual
Warning display when CCD camera
is installed
The following warning message is displayed
during use of the CCD camera: “Make sure of
safety around your vehicle”.
Switching the VTR system between
NTSC and PAL
Note:
• This setting is applied only to the VISUAL/VTR
input mode.
Changing the color of the
background picture
Turning on/off the motion of the
background picture
Front monitor lock
When an external device is connected to the
Visual terminal, lock the front monitor to show the
visual input source.
Note:
• This function is enabled only when the CONNECT
item of the GENERAL menu is set to other than
“NONE”.
1. Press the [MAP] button to set the monitor
lock.
The front monitor screen is locked to show the
visual input source.
2. To cancel the monitor lock, press the [MAP]
button.
The screen returns to show the image of the
selected mode.
Adjusting the GENERAL
1. Press the [ADJ] button, then touch the
[GENERAL] key.
2. Touch the [C] key to display the next menu
screen if desired.
3. Perform the adjustment for the desired item.
See the following sections for detail.
4. Touch the [Back] key to return to the previous
screen.
* In the following sections, only the details
regarding adjustments are described,
procedures to select items are skipped.
Setting the BEEP
The sound heard when you make operations is
called “beep”. The unit can be set up so that it
does not produce this beep sound.
• The factory default setting is “ON”.
Setting the Blink LED
When this function is set to “ON”, the Blink LED
indicator will blink when the ACC power is turned
off.
2-1. Touch the [ON] or [OFF] key of the
CAMERA WARNING item to turn this
function on or off (The factory default setting
is “ON”).
2-1. Touch the [NTSC] or [PAL] key of the
NTSC/PAL item to set the VTR system (The
factory default setting is “NTSC”).
2-1. Touch the []] key of the WALL COLOR item
to display the WALL COLOR screen.
2-2. Touch the desired Color you wish to set
(The factory default setting is “CYAN”).
2-1. Touch the [ON] or [OFF] key of the MOTION
item to set the function (The factory default
setting is “ON”).
3-1. Touch the [ON] or [OFF] key of the BEEP
item to turn the function on or off.
3-1. Touch the [ON] or [OFF] key of the BLINK
LED item to turn the function on or off (The
factory default setting is “OFF”).
• Setting the CATS function (see page 27)
turns on the Blink LED function as well.