Filter
Top Products
Chapter 3. Quick Setup
1. Placement
Page 39
Chapter 3. Quick Setup
1. Placement
Step 1. Preparation
Remove unit from out of the box and place it on the table top as seen below.
Figure 27 Table top placement
2. Connection
After unpacking the unit you must connect all camera connections, monitor connections, network
connection, power connection and other optional connections.
Step 1. Connect Cameras to DVR unit
Repeat this for number of cameras you are connecting to the DVR unit.
Example: If you are connecting 3 camera in 4ch DVR unit start with CH1
then to CH2 and finish to CH3 and do not connect to CH4
Figure 29 Camera to DVR
Figure 28 Example of 3 Camera Connections