Clover Electronics DV1670 DVR User Manual


 
Chapter 3. Quick Setup
4. Initial Boot
Page 42
4. Initial Boot
After turning on the DVR unit it will go into a boot sequence. At the initial boot section there is no user
interaction with DVR unit however please observe to see if DVR unit is properly booting.
As you may notice progress bar will indicate booting
progression, if there is no activity for long period of time then
possible corrupt or damaged firmware in DVR unit. Please
indicate such failure and contact technical support.
Figure 35 Live Screen View
If you have camera properly connected you will see cameras connection as indicated in figure 34 in CH1
and CH2 but if you do not have camera connect as you see in Ch3 and Ch4 you will see “VIDEO LOSS”
indication as you see in above figure. Please check your cable connection if you have
Figure 34 Initial Boot screen
Figure 33 Booting in progress