Clover Electronics DV1670 DVR User Manual


 
Chapter 9. Systems Section In-Depth
1. INFORMATION GUI
Page 69
Remocon ID (Remote Controller ID)
This ID setting enables to control more than two DVRs with one remote controller. Order of
configuration is first you need to select DVR to have ID that are not going to conflict with other DVR(s).
Set the ID per each DVR and match the ID for use.
Figure 58 Remote Controller ID
The default value for the ID is “00”. Change it to other value other than “00”. Let’s say that we change
the remote controller ID to “02” and then exit out of the GUI menu and save. Then point the remote
controller and press the red button labeled ID.
Figure 59 Remote Controller ID Button on remote controller