Filter
Top Products
31
ENGLISH
B
When “MULTI CHANNEL” is selected, use the
•
and
ª
cursor
buttons to select the item to be set, then press the ENTER button.
SPEAKER CONFIGURATION
Use this to select the types of the different speakers.
CHANNEL LEVEL
Use this to adjust the output level of the different speakers.
DELAY TIME
Use this to set the distance from the different speakers to the
listening position.
✽
To exit the SPEAKER SETUP mode
Use the
ª
cursor button to select “AUDIO SETUP” then press
ENTER button.
✽
The SPEAKER CONFIGURATION settings only apply to analog
outputs.
B
When “SPEAKER CONFIGURATION” is selected, use the
•
and
ª
cursor buttons to select the speaker to be set then press the ENTER
button.
• The type of speaker used for the front speakers, center speaker,
subwoofer and surround speakers can be set. Use the
•
and
ª
cursor buttons to select the speaker type, then press the ENTER
button.
LARGE
Select this when a large speaker is connected.
SMALL
Select this when a small speaker is connected.
NONE
Select this when no speaker is connected.
YES
Select this when a subwoofer is connected.
NO
Select this when no subwoofer is connected.
B
When “FILTER” is selected:
ON (Factory default)
Set to “ON” to play sources in the Dolby Digital and PCM multi-
channel modes.
OFF
DTS recommended all-channel full band playback setting. (Note
however that the subwoofer volume increases by 5 dB, by 15 dB
when playing Super Audio CDs.)
Set this to play DVD audio 6-channel sources recorded in all-channel
full band frequencies.
When “OFF” is set, the speaker size is set to “LARGE” for all the
speakers and the subwoofer setting is set to “YES”.
To play this type of disc, read the disc’s instructions carefully and
make analog connections.
✽
Press the RETURN button to return to the “SPEAKER SETUP”
menu.
B
When “CHANNEL LEVEL” is selected, use the
•
and
ª
cursor
buttons to select the speaker to be adjusted, then use the
0
and
1
cursor buttons to set the level.
SW +10 dB
Depending on the connected amplifier, it may not be possible to
increase the subwoofer level to balance it with the level of other
channels. In this case, the SW +10 dB function can be used to
boost the subwoofer output.
When turned on, the subwoofer output is increased by +10 dB.
✽
Never play at high signal levels (full scale or near full scale)
when the SW +10 dB mode is turned on. The signal level could
exceed the amplifier’s tolerance input level, resulting in noise
that could damage the speakers.
SPEAKER SETUP
SELECT: DECISION:ENTER BUTTON
SPEAKER CONF IGURAT ION
CHANNEL L EVEL
DELAY T I
M
E
AUDIO SETUP
SPEAKER SETUP
SELECT: DECISION:ENTER BUTTON
SPEAKER CONF IGURAT ION
FRONT SP
CENTER SP
SUB
W
OOFER
SURROUND SP
FILTER
LARGE
S
M
ALL
SPEAKER SETUP
SELECT: DECISION:ENTER BUTTON
CHANNEL L EVEL
TEST TONE
FRONT Lch
CENTER
FRONT Rch
OFF
0dB
0dB
0dB
0dB
0dB
0dB
SURROUND Rch
SURROUND L ch
SUB
W
OOFER
OFF
SW
10dB
+
Remote control unit
ENTER
Remote control unit
Remote control unit
3