Filter
Top Products
(2) Loading Discs
How to load a disc
• Make sure the drawer is completely open.
• Hold the disc by the edges and place it on the disc tray. (Do not
touch the signal surface, i.e., the glossy side.)
• Set the disc properly in the tray according to its size.
Set 8 cm discs in the center hole.
Set 12 cm discs in the outer hole.
• When the drawer is opened during the stop mode, discs can be
loaded in the 5 disc trays. If the DISC SKIP button is pressed, the
carousel turns and a disc can be loaded in the another disc tray.
When the drawer is opened during the play mode, it is possible to
load and unload discs in all of the disc trays other than the one
whose disc is currently playing. 5 discs can be replaced and press
the DISC SKIP button to switch the other disc tray that can be
replaced.
• Press the OPEN/CLOSE button (5) to close the drawer.
LABEL SIDE
UP WARD
NOTES:
• Remove all discs before moving the player.
• The player will not operate properly and the disc may even be
damaged if it is not set correctly.
• If your finger should get caught in the drawer when it closes,
press the OPEN/CLOSE button (5).
• Do not place any foreign objects on the disc tray and do not
place more than one disc on the tray at a time. Otherwise
malfunction may occur.
• Do not push in the disc tray manually when the power is off as
this may cause malfunction and damage the DVD video auto
changer.
• Do not touch the carousel while it is turning. Also, do not turn
the carousel by hand when it is stopped. Doing so could
damage it.
• Do not insert disc where indicated by arrow.
This could damage the internal mechanism in the unit.
• Do not hit the set strongly when a disc is loaded. Doing so may
scratch the disc or cause the DVD video auto changer to stop
operating.
ENGLISH
21