Legal notices
33
DX-19LD150A11/DX-22LD150A11
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party
responsible for compliance with the FCC Rules could void the user’s
authority to operate this equipment.
DHHS and FDA safety certification
This product is made and tested to meet safety standards of the FCC,
requirements and compliance with safety performance of the
U.S. Department of Health and Human Services, and also with FDA
Radiation Performance Standards 21 CFR Subchapter J.
RSS 310 statement
To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
Canada ICES-003 statement
This Class B digital apparatus complies with Canadian ICES-003.
Standard Television Receiving Apparatus — Appareil de réception
télévision ordinaire, Canada BETS-7 / NTMR-7
Notices
Specifications and features are subject to change without notice or
obligation.
For service and support call (800) 305-2204.
HDMI
HDMI, the HDMI logo, and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LCC.
This product contains software that is subject to the GNU Public License
Version 2 (GPL2). You can obtain a copy of the GPL License from
http://www.gnu.org/licenses/old-licenses/gpl-2.0.html.
If you require additional information or you wish to receive source code,
please call the Dynex support line at 1-800-305-2204. The source code
is available for a period of three (3) years from the date of the
distribution of this product by Dynex.
USB Compliance
USB 2.0
Device compatibility
USB flash drive
Power Input voltage
19-inch - 120 VAC, 0.6 A
22-inch - 120 VAC, 0.88A
Consumption
19-inch - <32.4 W
22-inch - <42.2 W
Off - <1 W
Speaker output
3 W (two channels)
Terminals Standard AV
Video, audio L/R
S-Video
S-Video, audio L/R
Component
Y, Pb, Pr, audio L/R
HDMI 1 and 2
HDMI IN
VGA and VGA/DVI
AUDIO IN
VGA and audio input
Phone jack
Audio out (headphone)
Digital audio
SPDIF output
Antenna
F type
Image processor Broadcom Xilleon™ X143
Operating
conditions
Temp erature
15 to +40°C (humidity <75%)
Humidity
10 to 90% non-condensing
(Ta <35%)
Atmospheric pressure
0 to 2000 m
DX-19LD-22LD_10-0118.book Page 33 Monday, February 1, 2010 1:44 PM