Filter
Top Products
16
Adjusting the pictureDX-40L150A11
• Cinema (stretches the picture at the edges, but
maintains a good aspect ratio at the center of the
screen).
Note: The above aspect ratios are all available only when Overscan is
turned ON when watching a digital program.
• Overscan—Turn this On to adjust the picture’s
reproduction rate.
• Color Temperature—Selects the color temperature. You
can select Warm (to enhance the reds), Cool (to enhance
the blues), or Normal.
• Noise Reduction—Selects the noise reduction mode to
reduce picture noise (snow). You can select Low, Middle,
High, or Off.
•Backlight—Controls the overall brilliance of the screen.
• Advanced Contrast—Opens the Advanced Contrast
submenu. Turn this On to optimize the picture display for a
more vivid image. You can also set the Dynamic Contrast
Ratio to On to automatically adjust the contrast between the
light and dark areas of the picture.
4 Press MENU to return to the previous menu, or press EXIT to
close the menu.
Adjusting the computer image
Note: These settings are only available when the input source is VGA and
your TV is receiving a computer signal.
To adjust the computer image:
1 Make sure that your TV is in VGA mode. For more information, see
“Selecting the video input source” on page 13.
2 Press MENU. The on-screen menu opens.
3 Press or to highlight SETTINGS, then press . The
SETTINGS menu opens.
4 Press or to highlight Computer Settings, then press
ENTER. The Computer settings menu opens.
5 Press or to highlight an option, then press or to adjust
the option. You can adjust:
• Auto Adjust—Automatically adjusts the image settings
such as position and phase.
• H-Position—Moves the image right or left.
• V-Position—Moves the image up or down.
• Clock—Adjusts the sample frequency.
• Phase—Adjusts the focus of stable images.
• Reset Computer Settings—Resets the computer settings
to factory default.
6 Press MENU to return to the previous menu, or press EXIT to
close the menu.
Setting the component image
Note: These settings are only available when the input source is
Component and your TV is receiving a signal.
To set the component image:
1 Make sure that your TV is in Component mode. For more
information, see “Selecting the video input source” on page 13.
2 Press MENU. The on-screen menu opens.
3 Press or to highlight SETTINGS, then press . The
SETTINGS menu opens.
ENTER MENU EXIT
PICTURE
Mode
Advanced Video
Brightness
Contrast
Color
Tint
Vivid
70
50
60
0
+10
Sharpness
MOVE SELECT PREVIOUS EXIT
AUDIO SETTINGS CHANNELS
ENTER TIXEUNEM
PICTURE
Parental Controls
Closed Caption
Time
Menu Settings
Input Labels
Computer Settings
Component Settings
MOVE SELECT PREVIOUS EXIT
AUDIO SETTINGS CHANNELS
ENTER MENU EXIT
PICTURE
Auto Adjust
50
50
50
50
H. Position
V. Position
Clock
Phase
Reset Computer Settings
MOVE SELECT PREVIOUS EXIT
AUDIO SETTINGS CHANNELS
ENTER MENU EXIT
PICTURE
Mode
Advanced Video
Brightness
Contrast
Color
Tint
Vivid
70
50
60
0
+10
Sharpness
MOVE SELECT PREVIOUS EXIT
AUDIO SETTINGS CHANNELS
ENTER TIXEUNEM
PICTURE
Parental Controls
Closed Caption
Time
Menu Settings
Input Labels
Computer Settings
Component Settings
MOVE SELECT PREVIOUS EXIT
AUDIO SETTINGS CHANNELS
DX-40L150A11_10-0017.book Page 16 Tuesday, February 16, 2010 4:15 PM