Filter
Top Products
LC-XC1
38
The Wireless Remote Control Unit is not only able to operate the projector but also usable as a wireless
mouse for most Personal Computers. The POINT buttons and the
two
CLICK buttons are used for the
wireless mouse operation.
The wireless mouse is available only when PC mouse pointer is displayed on the screen. When the menu or
the indicator of the projector is displayed on the screen instead of the PC mouse pointer, the wireless mouse
cannot be used.
INSTALLATION
To use the Wireless Remote Control Unit as the Wireless Mouse for a Personal Computer, installation of the
mouse driver (not supplied) is required. Make sure that the mouse driver is properly installed in your
computer. And make sure that the mouse port of the computer connected to Control Port is activated.
1
Connect the mouse port of your computer to the Control Port of
the projector with the Control Cable. (Refer to page 11 to 14 for
connection.)
2
Turn the projector on first, and then turn on your computer.
When the computer is switched on first, the Wireless Mouse may
not work properly.
OPERATING WIRELESS MOUSE
When controlling the pointer of the computer, operate the
Wireless Mouse with POINT button, SELECT button, and
RIGHT CLICK button on the Wireless Remote Control Unit.
POINT button
Used to move the pointer. The pointer
is moved corresponding
with the direction you are pressing.
SELECT (LEFT CLICK) button
This button has the same function as the left button
in a
PC
mouse.
RIGHT CLICK button
This button has the same function as the right button in a PC mouse. Pressing this button does not affect any
operation when in Menu
mode.
Note: When the computer has no
mouse port, connect the
Serial Port of the computer to
Control Port of the projector
with the Control Cable for
Serial Port.