Filter
Top Products
FUJITSU PC CORPORATION
Stylistic 3400 is a trademark of Fujitsu PC Corporation © 2000 Fujitsu PC Corporation
1/00 58-0703-00A
FMWCC43
Slipcase
Installation Guide
Stylistic 3400
These instructions provide details on using the
FMWCC43 slipcase. This case is designed for use
with the Stylistic 3400 pen tablet. The slipcase
provides added protection when transporting,
using, or storing the pen tablet.
Note: Prior to installing your pen tablet in the
slipcase, be sure to install a screen protector on
the screen. It is difficult to install a screen
protector once the system is in the slipcase.
Installing the pen tablet 0
To install your pen tablet into the slipcase, open
the side flap of the slipcase. The flap is secured by
a long strip of Velcro
®
that is attached to the back
of the slipcase (see Figure 1).
Figure 1. Stylistic 3400 Slipcase - Rear
Slide the system into the slipcase, with the screen
facing the open window. Reattach the flap to the
side of the slipcase.
Note: The removable Antenna Cover Hood illustrated
in Figure 1 is discussed later in this procedure. It
is designed to accommodate a Stylistic 3400
containing a radio with a protruding antenna
with the optional Antenna Cover Kit installed.
Velcro®
strip
Antenna Cover Hood
Handstraps
D-rings
Antenna Cover Hood attachment strip
Figure 2. Stylistic 3400 Slipcase - Front
The ends of the elasticized handstraps have a D-ring to
which you can attach the shoulder strap. To secure the
shoulder strap, attach the strap clips to two of the
D-rings. The slipcase can be carried vertically or
horizontally, depending on how you orient the clips.
Attaching the Antenna cover hood 0
For Stylistic 3400 pen tablets that are equipped with
radios, an optional Antenna Cover (FMW42RC1) may
be attached to the system to protect the protruding
antenna. To protect the Antenna Cover, each slipcase
includes a removeable nylon Antenna Cover Hood.
Note: • For installation instructions for the Antenna
Cover, reference the instructions that
accompany it. The following instructions are
solely for installing the Antenna Cover Hood.
• Install the Antenna Cover prior to installing
the Antenna Cover Hood.
1. Position the hood over the Antenna Cover to ensure
a good fit.
2. Remove the hood from the cover and detach the
paper covering the adhesive Velcro® strip on the
inside of the hood.
PC Card/
Radio Slot
Side
Flap