Filter
Top Products
M2488 PRODUCT GUIDE ASC/ASCQ
April 1997 CG00000-011503 REV. A B-3
.
4 Reissue the same command.
5 Request manual assistance.
6 Issue log sense commands to read counter pages. Refer to Chapter 4 for information on the log
sense commands.
7 The Host operating system must analyze the condition to see if it is acceptable for the processing
currently being performed. If acceptable, additional action is required prior to continuing pro-
cessing, e.g.; cause a new tape to be mounted for multi-volume operation.
8
In the event of a READ REVERSE command, issue a READ command to read forward, then
issue a SPACE command to space back one block. Otherwise treat as a permanent error.
9 Report all 44 bytes of SCSI sense data to the Product Support Engineer.
Table B-3. ASC and ASCQ Description (by ASC/ASCQ)
ASC/ASCQ
SENSE
KEY
DESCRIPTION
00 00 0 No additional sense available
3 No additional information
00 01 0 Filemark detected
00 17 1 Clean Requested. NOTE: This ASC/ASCQ can only be generated when feature mode FT5, bit 5
(0x20) is set to one as described in the configuration settings in the M2488 User’s Guide.
00 02 0 End-of-Medium detected
3 End-of-Medium detected
D End-of-Medium detected
00 04 0 Beginning-of-Medium detected
00 05 8 Tape void
04 00 2 Logical unit not ready, cause not reportable
3 Manual unload and buffered write data exists
04 01 2 Not ready, in process of becoming ready. NOTE: This ASC/ASCQ can only be generated when
feature mode FT4, bit 5 (0x20) is set to one as described in the configuration settings in the
M2488 User’s Guide.
04 03 2 Load assistance required
3 Load assistance required and buffered write data exists
0C 00 1 Recovered write error
3 Write error
11 00 3 Unrecovered read error
14 04 3 Block sequence error
17 01 1 Recovered read data with retries
1A 00 5 Parameter list length error
20 00 5 Invalid command operation code
21 01 5 Invalid medium changer element address
24 00 5 Invalid field in CDB
25 00 5 Logical unit not supported
26 00 5 Invalid field in parameter list
27 00 7 Write protected
Table B-2. Action Advised Codes (Continued)
ADVISED
ACTION CODE
DESCRIPTION