Filter
Top Products
Note: WPS is incompatible with WEP security. If WEP is configured in the gateway
then WPS cannot be enabled.
Wireless Cable Voice Gateway CG3000/CG3100 User Manual
Wireless Configuration 2-13
v1.0, July 2009
3. Select Enable in the WPS Config field and click Apply.
4. In the WPS Method fie
ld, select PIN.
5. W
rite down the STA PIN number.
6. Go
to the client wireless computer. Run a WPS configuration utility. Follow the utility’s
instructions to enter the gateway STA PIN number.
7. On
the Wireless Settings screen, click Start WPS.
• The WPS LED on the front of the gateway begins to blink.
• The gateway tries to communicate with
the client for 4 minutes.
• If the Security Option in the Wireless Settings scree
n was set to Disabled, the gateway
automatically changes it to WPA-PSK (including a PSK security password).
When the gateway adds the WPS client, it sends the SS
ID and WPA-PSK or WPA2-PSK
configuration to the client.
To access the Internet from any computer connected to
your gateway, launch a browser such as
Microsoft Internet Explorer or Mozilla Firefox. You should see the gateway’s Internet LED blink,
indicating communication to the ISP.
Connecting Additional Wireless Client Devices
You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.
Adding Just WPS Clients
To add a wireless client device that is WPS-enabled, follow the procedures in “Using a WPS
Button to Add a WPS Client” on page 2-10 or “Using a PIN Entry to Add a WPS Client” on
page 2-12.