Filter
Top Products
4
Front Panel
Back Panel
1
5
2
6
3
7
4
8910
1 Power LED
This LED will activate once a valid power source is applied.
2 Internal EDID LED
This LED will activate only when the pre-programmed internal EDID is being
used. Please see page 6 for more details on the internal EDID.
3 External EDID LED (default EDID routing)
This LED will activate only when the external EDID is being used. Please
see page 6 for more details on the external EDID.
4 Link LED
This LED will activate when a valid link between the source and the splitter is
detected.
5 EDID Button
This button will activate the onboard EDID. Press this button (the Int. EDID
should turn on and the Ext. LED should turn off) and reset the unit using the
Reset button (below) to initialize this EDID mode. To use an external EDID,
press the EDID button again (the Int. LED should turn off and the Ext. LED
should turn on) and press the Reset button to initialize this EDID mode.
6 Reset Button
This button will reset the unit and initialize whichever EDID mode is currently
selected.
PANEL DESCRIPTIONS