Filter
Top Products
INSTALLATION
34 PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
D. Bolt the Segmented Rubber Wheel to the
Enclosed Chain Drive Assembly Wheel Shaft
Weldment with four (4) ½” Nylock nuts.
E. Make final adjustments to the Back Shields and
mounting brackets, and tighten all hardware.
Remember to leave the Pivot bolt at the Gearbox
loose enough to pivot.
F. Inspect the “DANGER” decals on the Enclosed
Chain Drive Assembly Housing and the Back
Shields to insure legibility. If the decal cannot
easily be read or is missing, order a new decal
immediately from your dealer.
G. Open the Enclosed Chain Drive Lid and inspect
the chain. The chain should have a light coat of oil
on it. If it does not, lightly coat the chain with oil.
H. Close and secure the Enclosed Chain Drive Lid.
Do NOT Operate with the Enclosed Chain Drive Lid open.
A single section of Sweep Flight and Back Shield, or just a few sections, can
be used alone without all the other sections. Install the Sweep Wheel at the
end of the last section being used.
Segmented Rubber Wheel
1/2” Nylock Nuts
Enclosed Drive
Assembly Wheel Shaft
Weldment
FIG.12-D
12. SWEEP WHEEL INSTALLATION
(Cont.)