Heath Zenith Multi-Channel Remote Control Universal Remote User Manual


  Open as PDF
of 12
 
ENGLISH
© 2007 HeathCo LLC 598-1145-01
Multi-Channel Remote
Control
FEATURES
• Operational range of up to 100 feet.
• Controls all Heath
®
/Zenith RF Tech Communica-
tions™ products.
• FCC/IC tested and approved.
• Flash control on compatible receivers when using
the Panic feature.
A
L
L
O
N
A
L
L
O
FF
O
FF
DI
M
PA
NI
C
A
B
ON
BATTERY INSTALLATION
The Multi-Channel Remote
Control is designed for 3
Volt operation:
1. Remove battery cover
on rear of housing by
pushing clip and lifting
up.
2. Install 2-AAA bat-
teries (not included)
according to polarity
markings. For best per-
formance use alkaline
batteries.
Battery Cover
Two AAA Batteries
(Not Included)
Installing 2-AAA Batteries
PRODUCT IDENTIFICATION
*DIM Control: Dims lighting controls that are equipped with the dimming feature. Pressing DIM will toggle through the different dim
levels. Each time the DIM button is pressed, the control LED will momentarily light.
The receiver saves the last dim setting used. To recall the last dim setting, press the DIM control once.
Note: Not all lighting controls have the DIM and PANIC (flash) feature.
Control Group and Indicators - Select
Group A or B lighting controls.
ALL ON - Turns all lights within a Group ON.
Select either Group A or B then press ALL ON.
Light Control - ON
PANIC* - All lights within a Group will
flash ON and OFF. Select either Group A
or B then press PANIC.
ALL OFF - Turns all lights within a
Group OFF. Select either Group A or
B then press ALL OFF.
Control Identification - Remove clear plastic film by
placing two fingers on the plastic and “pinching” the
plastic. Remove card. Write on the card to label each
control. Replace card and plastic film.
Light Control - OFF
Light Control Selectors
Light Control - DIM*
ON
ALL ON ALL OFF
DIM
PANIC
A B
OFF
next