Filter
Top Products
4-67
Remote Operation
CALCulate Subsystem Commands
CALCulate[1|2|3|4|5|6]:TPOWer:IRANge[STATe] OFF|ON|0|1
CALCulate[1|2|3|4|5|6]:TPOWer:IRANge[STATe]?
Turns the total power calculation range for all traces
ON
or
OFF
. Setting
IRANge:STATe to
ON
will set the corresponding TPOWer:STATe to
ON
.
Although there is a single range controlling the total power integration, the
trace mean calculation, the marker search range, and the wavelength sweep
range, there are four independent state settings for limiting the total power
calculation, the trace mean, the marker search, and the wavelength sweep to
the range. If all four states for the total power integration, the trace mean, the
marker search, and the wavelength sweep range are
OFF
, setting the CALCu-
late:TPOWer:STATe to
ON
, will initialize the lower limit to and the
upper limit to .
Sending the command when the instrument is in a zero span will generate a
“Settings conflict” error.
CALCulate[1|2|3|4|5|6]:TPOWer:IRANge:UPPer <numeric_value>[M|UM|NM|A|HZ|KHZ|MHZ|GHZ|THZ]
CALCulate[1|2|3|4|5|6]:TPOWer:IRANge:UPPer?
Sets the upper X-axis limit of the total power integration range for all traces.
Setting this value when the CALCulate:TPOWer:IRANge[:STATe] is
OFF
will
automatically turn the CALCulate:TPOWer:IRANge[:STATe]
ON
. The range
used for the total power calculation is the same range used for the marker
search range, the trace mean range and the wavelength range. Changing the
range with this command will change all four ranges.
Default units for the parameter are meters. Sending the command when the
instrument is in a zero span will generate a “Settings conflict” error.
CALCulate[1|2|3|4|5|6]:TPOWer:STATe OFF|ON|0|1
CALCulate[1|2|3|4|5|6]:TPOWer:STATe?
Turns the total power calculation for a trace
ON
or
OFF
. Only one total power
calculation can be turned on at a time. For example, if a total power calcula-
tion is being performed on trace A, turning a total power calculation for
trace B
ON
will turn the calculation for trace A
OFF
. Turning this function
ON
in
zero span generates a “Settings conflict” error.
start
span
3
-------------+
start 2
span
3
-------------×
+
book.book Page 67 Monday, January 31, 2000 10:34 AM