Filter
Top Products
REAR PANEL JACKS
12
ቨ RGB - Analog Input
Use this 15-pin D-Sub input for your external devices with RGB output (see page 22).
ቩ RGB - Audio Input
Connect audio for RGB input (if you have mono sound, insert the audio cable into the left audio jack).
ቪ DVI - HDTV - Digital Input
Use this DVI Digital input for your external devices with digital output capability, such as a Set-Top-Box, high band DTV decoders
and DVD players with digital content protection (see page 22). DVI is INPUT 1 and has priority over component input. When DVI
is used, hook up audio to INPUT 1.
ቫ To Monitor
Connect the Monitor Connection Cable to the AVC center’s “TO MONITOR” connector, and to the display monitor’s “FROM AVC”
connector.
ቭ IR Blaster
This jack provides IR output to your external components (VCR, Cable box, DVD player, etc.). With this connection, your external
components can automatically be controlled by the A/V network feature. This connection will allow you to control the external
components with your Plasma Television’s remote control in TV mode.
ቮ Subwoofer Out
Connect this SUB WOOFER OUT output to the external audio component input using the sub woofer cable provided.
Sub-woofer cable (RCA Type)
ቯ To AVC
Connect the Monitor Connection cable from the AVC center’s “TO MONITOR” to these connectors (“FROM AVC”).
ተ SUB-POWER button
This power is for serviceman usage.
ቱ To Power Swivel base (32” and 42” Only)
Connects the plasma monitor to the power swivel base using a connection cable.
FIRST TIME USE
Ferrite Core
NOTE: When using a Set-Top-Box, it is recommended to use a 1080i or 720p input signal.
NOTES: 1. Squeeze both ends of the cable connector before inserting or disconnecting from the monitor and power swivel
base.
2. The monitor base and the power swivel connection cable must be disconnected before wall mount installation.