Filter
Top Products
FIRST TIME USE
7
Do not block the ventilation holes of the Plasma •
Television. Blocking the ventilation holes might
cause re or defect.
In case of an abnormal symptom, unplug the AC •
cord and contact 800-HITACHI.
If you purchased a wall mount bracket, please ask •
for professional installer. Do not try to install by
yourself.
Install the unit at a proper area where it does not •
expose anyone to any danger of hitting themselves
(for example their hands, head or face, etc.) against
the edge of the unit that could cause personal
injury.
AC Cord Installation
The AC cord provided with your new Plasma Television needs to
be installed correctly to avoid its disconnection when rotating the
TV on its Table Top Stand.
Located on the back of the TV there are 2 plastic clamps to hold
the AC cord. Please follow the instructions below.
q Pass the AC cord through Clamp #2 and then Clamp #1 and
connect it to the TV.
w Close clamp #1 to x the AC cord to the TV.
e Pull on clamp #2 to tighten the AC cord to the TV.
Clamp #1
Clamp #2
How to secure Clamp #1
Hook
To SET•
Set the clamp
in the direction
of the arrow
To UNFASTEN•
Loosen the hook
and pull in the
direction of the
arrow
How To Install Your New Hitachi Plasma Television
Caution when moving the main unit
As this product is heavy, whenever it is moved, at least two people
are required to transport it safely. Whenever the unit is moved it
should be lifted forward using the top and base on both sides of the
Television for stability.
When moving the Television, lift from the handles (42”), or use the
corners (50”) then support the top frame as shown below.
Location
Select an area where sunlight or bright indoor illumination will not
fall directly on the picture screen. If so, drapes or screens can be
used to reduce the reection.
Also, be sure that the location selected allows a free ow of air to
and from the perforated back cover of the set. In order to prevent an
internal temperature increase, maintain a space of 10 cm (4 inches)
from the sides/back of the Television, and 30 cm (12 inches) from
the top of the television to the ceiling. To avoid cabinet warping,
cabinet color changes, and increased chance of set failure, do not
place the TV where temperatures can become excessively hot, for
example, in direct sunlight or near a heating appliance, etc.
10 cm
(4 inches)
30 cm (12 inches)
10 cm
(4 inches)
Securing to a Table-Top
Using 2 commercially available wood screws fasten the set 1.
through the clamping screw holes on the rear of the Plasma
Table Top Stand as shown below.
Securing to a Wall
Using metallic wire (two places) fasten the set to the clamping 1.
screw on the rear of the Plasma TV as shown below.
Wire
Clamp
Screw
Wire
Wood Screws
2 places
Keep the Plasma television 4 inches away from the wall except 2.
when mounted using the wall mount bracket and secure to the
wall as shown below:
Wire
Wire
A B
A
42”
50”
4 in.
10 cm.
To take measures to prevent the Plasma Television from tipping over and prevent possible injury it is important to mount the unit
inastableandatsurface.
NOTES
42” 50”