Humax PVR-8000 DVR User Manual


 
GBGB39
Main Menu Guide
1. Move cursor to Wakeup Service No.
2. Select the desired service, using the buttons. Use the
TV/RADIO( ) button on the remote control unit to toggle
TV/Radio service.
Depending on Time Setting, select the time when STB is turned
off.
1. Move the cursor to Sleep Time.
2. Press the button to select enabled or disabled.
3. If Enabled is selected, the Time Input window will appear.
4. Enter the time in the order of hour and minute, using the
NUMERICAL buttons.
5. Press the OK button to complete Sleep Time setting.
You select the STB output by using the UHF channel.
Select an UHF channel. The range of channels and frequency
value is different for each PAL Standard:
PAL I/G for Europe : CH21 ~ CH69
PALB for Europe/Australia : CH28 ~ CH69
PAL D for China : CH13 ~ CH62
PALK for Russia : CH21 ~ CH69
1. Move the cursor to Channel.
2. Select the desired UHF channel using the buttons.
1. Move the cursor to PAL standard.
2. Use the buttons to select a PAL Standard according to
the above range of channels.
1. Move the cursor to offset.
2. Use the buttons to Adjust the fine tuning value.
The Offset ranges from -4 to +4 and each Offset represents
1MHz.
Wakeup Service No.
UHF Tuning
Sleep Time
Channel
PAL Standard
Offset
PVR-8000 ENG 1/21/03 11:10 PM Page 44