Filter
Top Products
GBGB52
Motorised System
If you have a Motorised System for DiSEqC1.2, you can set the Motorised System item to
Enable on Antenna Setting window and add necessary
functions. If a Motorised System is set to Enable, you
cannot select DiSEqC Input items but, instead, you can use
new menus(Satellite Name, DiSEqC Command Mode,
Movement and Limit Setting) on Antenna Setting window
and the Goto/Store items are added to Operation
window(User mode).
In case that a Motorised System is Enabled, if you have defined Satellite Name on the
Window and also created the location information about the
satellite, you can drive the motor which corresponds to the
Satellite Name by moving the cursor and selecting ‘Goto’.
Otherwise, you need to move to the Item window by using
the buttons in the DiSEqC Command mode of the
window and select Installer. Then, you will find that the
Reset command is added as Motor Control Command on
Operation window, which is different from the User mode.
After selecting your Motorised System as Installer, move to and select the Movement item
on the window, and move the cursor to Item by using the
buttons and then select East or West by using the
buttons. Now, the motor will start to be driven.
If it starts to be driven, move East/West until you find the
location at which signal quality is best. If multiple locations
are found, you should select other frequency and drive the
motor again until only a single location is found.
You can select Stop at the best location by using the signal
level and signal quality bar on the bottom of the window and then move the cursor to Oper-
ation window and select Store the item to save the current location information. Be careful
that if you exit the menu without saving this location information, the current Satellite loca-
tion information will be lost. Repeat the above steps for other Satellites to use your
Motorised System for them.
Once you have set the location information for a satellite, you can perform fine-tuning for
its location information If you start to search services from the location information
previously saved.
DiSEqC 1.2 User Instructions
PVR-8000 ENG 1/21/03 11:10 PM Page 57