IBM 8480 Home Theater Server User Manual


 
Chapter 1. Introducing the xSeries 205 Type 8480 server 3
Features and specifications
The following table provides a summary of the features and specifications. Some
features and specifications are not available on all models.
Microprocessor: Supports one
microprocessor — Intel
®
Pentium
®
4
with 128 KB, 256 KB, or 512 KB
Level-2 cache and 400 MHz or 533
MHz front side bus (FSB)
Memory:
Minimum: 128 MB
Maximum: 2.0 GB
Type: PC2100 266 MHz double-
density RAM (DDR) DIMMs
Slots: Two dual inline
Drives: (depending on your model)
Diskette: 1.44 MB
Hard disk drive: IDE or SCSI
One of the following:
—CD-ROM: IDE
DVD-ROM: IDE
CD-RW: IDE
Expansion bays: (depending on
your model)
Two 5.25-in. bays (one CD-
ROM drive installed)
Two 3.5-in. bays (one diskette
drive installed)
Three 3.5-in. hard disk drive
bays: hot-swap drive bays
(some models) or non-hot-swap
drive bays with a hard disk drive
installed (some models)
PCI expansion slots:
Three 33 MHz/32-bit on the
system board (some models
come with a SCSI adapter
installed)
Two 33 MHz/32-bit on the PCI
extender board
Video controller: ATI Rage XL
video controller with 16 MB SDRAM
video memory on the PCI extender
card
Power supply: One 340 watt (90-
240 V ac)
Size and weight:
Height: 445 mm (17.5 in.)
Depth: 498 mm (19.6 in.)
Width: 165 mm (6.5 in.)
Weight: approximately 19.5 kg (43
lb) when fully configured or 15.9 kg
(35 lb) minimum
Integrated functions:
Broadcom 5702 10/100/1000
Ethernet controller on the system
board with RJ-45 Ethernet port
Two serial ports
One parallel port
•Two USB ports
Keyboard port
•Mouse port
•Audio ports
—Line out
—Line in
—Mic
Dual-channel bus mastering IDE
controller
Support for IBM Remote Supervisor
Adapter
Acoustical noise emissions:
Sound power, idling: 5.1 bel
maximum
Sound power, operating: 5.3 bel
maximum
Environment:
Air temperature:
Server on: 10° to 35° C (50.0° to
95.0°F). Altitude: 0 to 2133 m
(6998.0.7 ft)
Server off: 10° to 43° C (50.0° to
109.4°F). Maximum altitude:
2133 m (6998.0 ft)
Humidity:
Computer on: 8% to 80%
Computer off: 8% to 80%
Heat output: Approximate heat output
in British thermal units (Btu) per hour
Minimum configuration: 341 Btu
(100 watts)
Maximum configuration: 1604 Btu
(470 watts)
Electrical input:
Sine-wave input (50-60 Hz)
required
Input voltage low range:
Minimum: 90 V ac
Maximum: 137 V ac
Input voltage high range:
Minimum: 180 V ac
Maximum: 265 V ac
Input kilovolt-amperes (kVA)
approximately:
Minimum: 0.095 kVA
Maximum: 0.470 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features installed and the power-
management optional features in
use.
2. These levels were measured in
controlled acoustical environments
according to the procedures
specified by the American National
Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby noise
sources. The declared sound-
power levels indicate an upper limit,
below which a large number of
computers will operate.