Filter
Top Products
12
www.insigniaproducts.com
Connecting a digital sound system
To connect a digital sound system:
1 Make sure that your TV’s power cord is
unplugged and the digital sound system is
turned off.
2 Connect a digital optical audio cable to the
S/PDIF IN jack on the digital sound system.
3 Connect the other end of the cable to the
DIGITAL OUTPUT jack on the back of your TV.
Connecting headphones
To connect headphones:
• Connect the headphones to the headphone jack
on the side of your TV.
Connecting an FM radio antenna
To connect an FM radio antenna
• Connect the FM antenna (provided) to the FM
antenna jack on the side of your TV.
To listen to FM radio:
1 Turn on your TV, then press INPUT. The INPUT
SOURCE menu opens.
2 Press or to select FM, then press ENTER.
Turni ng on your T V for the
first time
Before you use your TV the first time, make sure to
remove the protection film from the back cabinet,
otherwise the ventilation openings will be blocked,
which may cause overheating and other serious
problems.
To configure your TV:
1 Make sure that you have inserted the battery in
the remote control, connected the antenna to
the TV, and connect the AC power.
2 Press (Power), then wait several seconds. The
initial setup screen opens (only the first time
you turn on your TV).
Note
The DIGITAL OUTPUT jack works with digital TV
channels only.
Note
Loud noise can damage your hearing. When using
headphones, use the lowest volume setting that still
lets you hear the sound.
Back of TV
Digital output jack
Digital sound system
Optical audio cable
Side of TV
Notes
For best reception, fully extend the FM antenna.
Keep the FM antenna as horizontal as possible.
If FM reception is poor in your area, us an outdoor FM
antenna (not provided) and connect it to your TV
with 75 ohm coaxial cable (not provided).
Tip
You can also press FM on the remote control.
Side of TV
FM antenna
English
Français
Español
Choose your menu language
NS-L19X-10A_09-0241_MAN_V2_English.book Page 12 Tuesday, April 7, 2009 9:29 AM