Filter
Top Products
7
DVDB01
WIRING
Power/Accessory Connections
+
4
6
1 7
2
3
5
IR REMOTE CONTROL EXTENDER EYE
POWER WIRING HARNESS
1. – Connect to PADIN5.
2. – Position extender where you are
likely to use the remote control. Point remote at eye to control the unit.
3. (yellow) – Connect the 12V PLUS constant
power wire to a live 12 volt wire in the vehicle. Before making a
connection, check that the wire you intend to connect it to is always live,
even when the car’s ignition is turned off. If a live wire is not found, route
the wire to the car’s fuse block and connect it to a live circuit there.
– Provides 12VDC at 300mA when DVD is on.
7. Connect optional wired remote control.
P.A.
REMOTE CONTROL EXTENDER
CONSTANT POWER WIRE
4. (red) – Connect to a +12 volt circuit that is only live
when the ignition is on. The best connection point is at the car’s fuse block
at the “RADIO” or “ACCESSORY” identified terminals.
5. (black) – Securely fasten the Ground wire to a grounded
metal part of the car’s chassis. If you cannot find an existing bolt or screw
to fasten it to, drill a hole in the metal and secure it with a screw. To
ensure a good ground, remove any paint or grease from areas where the
wire will contact the surface.
6.
ACC POWER WIRE
GROUND WIRE
DC12V OUT
3A FUSE
1A FUSE
YELLOW
BLACK
RED
WIRED REMOTE