Filter
Top Products
12
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R).
How to set the DVD+VCR’s RF output
channel
1. When the DVD+VCR is turned off, press and hold
both CH - and CH + on the front panel for more
than five seconds. “RF03” or “RF04” appears in
the display window.
2. Press either CH - or CH + to change the RF out-
put channel (RF03 or RF04). Tune the TV to this
channel.
3. Turn off the DVD+VCR.
Audio/Video connection
1. Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using an
optional video cable (V).
2. Connect the Left and Right DVD/VCR AUDIO
OUT jacks on the DVD+VCR to the audio left/right
in jacks on the TV (A1) using an optional audio
cables.
Note:
If you use this connection, set the TV’s source selector to
VIDEO.
Optional
Optional
TV Connections
TV Connections
These connections support only DVD playback.
The tuner and VCR still output through the RF.OUT
(R) or DVD/VCR OUT (A, V) jacks.
Component Video / Progressive Scan
connection
If your television is a high-definition or “digital ready”
television, you may take advantage of the
DVD+VCR’s progressive scan output for the highest
video resolution possible.
1. Connect the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT jacks on the DVD+VCR to the
corresponding in jacks on the TV using an option-
al Y Pb Pr cable (C).
2. Connect the Left and Right AUDIO OUT jacks of
the DVD+VCR to the audio left/right in jacks on
the TV (A2) using an optional audio cables.
Notes:
• When you use Composite Video signal, set the
Progressive Scan to “Off” on the setup menu.
•Progressive scan does not work with the Composite
video connections (yellow VIDEO OUT jack).
• If your TV does not accept the Progressive Scan format,
the picture will appear scrambled. Switch to composite
video output.
A
A
udio Connection f
udio Connection f
or D
or D
VD
VD
You can listen to playback using DVD/VCR AUDIO
OUT (A1), AUDIO OUT (A2), COAXIAL (X) and RF.
OUT (R) connections. COAXIAL (X) and AUDIO OUT
(A2) is used only for listening to DVD playback.
(See page 11.)
Connecting to an amplifier equipped with
two channel analog stereo
Connect the Left and Right AUDIO OUT (or
DVD/VCR AUDIO OUT) jacks on the DVD+VCR to
the audio left and right in jacks on your amplifier,
receiver, or stereo system using an optional audio
cables (A1, A2).