JVC HR-XVC17SU DVD Player User Manual


 
15
Preparation
TUNING
This DVD+VCR is equipped with a frequency
synthesized tuner capable of receiving up to 181
channels. These include VHF channels 2-13, UHF
channels 14-69 and CATV channels 1-125.
Auto Channel Programming
1. Choose the SOURCE SELECT option, then use
b / B to select TUNER.
Use b / B to switch among TUNER, LINE1, and LINE2.
2. Choose the AUTO CHANNEL SET option, then
use b / B to find channels.
The tuner will automatically cycle through all available
channels (TV/CATV) in the area and place them in
the tuner’s memory.
After the AUTO CHANNEL SET is complete, the
TUNING menu will hide and return to the TV screen
automatically.
If the power fails or the DVD+VCR is unplugged the
channel settings are kept in memory for only 3 sec-
onds.
3. Make sure the TUNING BAND is set appropriately
(TV or CATV).
TV : If you are using a standard antenna to receive
channels.
•CATV : If you are using basic cable to receive
channels.
To Add or Erase Channels
This feature allows you to add or erase channels
from memory manually.
1. Choose the CH. ADD/DEL option, then use b / B
to select a channel to add or erase.
2. Use ENTER / OK to add or erase the channel.
Repeat steps 1 and 2 to add or erase other
channels.
3. Press SETUP MENU to return to the TV screen.
SETUP
FUNCTION OSD
The on-screen display can be turned on or off.
AUDIO MODE
The DVD+VCR has two separate audio playback sys-
tems, the high quality VHS Hi-Fi system and standard
NORMAL mono system. The same audio is generally
recorded on both systems. The VHS Hi-Fi system
plays on separate (left and right) channels, and the
NORMAL system plays monaural sound. The normal
track is always played so the cassette can be played
on a DVD+VCR that does not have VHS Hi-Fi.
BROADCAST TYPE (STEREO / SAP / MONO)
Multichannel Television Sound (MTS) carries stereo
and/or Second Audio Program (SAP) bilingual signals.
Set this display to the desired position when both
MTS stereo and SAP signals are received. When only
one of the MTS signal is received, the DVD+VCR
automatically selects the corresponding receiving
mode (Stereo or SAP) regardless of the selected
position. For normal operation, the display should be
in the STEREO position. The DVD+VCR will then
record a STEREO program when available, and
record a mono program IF the program is NOT IN
STEREO. For weak STEREO and/or SAP broadcasts,
changing the display to mono may give clearer sound.
AUDIO OUTPUT (STEREO / LEFT / RIGHT)
Used during playback [when AUDIO MODE (HI-FI/
NORMAL) is in HI-FI position] for selecting the audio
output signals from the AUDIO OUT terminals (L ch
and R ch), and RF.OUT. This display setting should
normally be left in the stereo position, so that when a
stereo tape is played, the stereo sound will be heard
through the left and right channels. If a mono tape is
played and the audio output is set to stereo, the
same mono sound will be heard from both left and
right channels.
In addition to the above settings, these other sources
are also affected:
1. Playback of CD, DVD or VCD
2. Output of built in tuner, Line 1 or Line 2