Filter
Top Products
10
Connecting an Antenna or
Cable TV
Antenna:
Disconnect the antenna from the rear of the TV and
identify the antenna cable. If it is a round 75 ohm
coaxial cable connect it directly to the jack marked
ANT.IN on your DVD+VCR. If your antenna cable
is flat connect it to a 300-ohm to 75-ohm antenna
adaptor (not supplied) and slip the adaptor over the
ANT.IN jack. Don’t attempt to screw it into to the
DVD+VCR.
Cable TV:
If your cable connection has no converter or
descrambler, unscrew the cable from your TV and
attach it to the ANT.IN jack on the DVD+VCR. If a
converter is required connect a coaxial cable from the
wall jack to the IN connector on the converter, and
a coaxial cable from the OUT connector on the con
-
verter to the ANT.IN on your DVD+VCR. This cable
hookup permits both TV and DVD+VCR operation.
Rear of DVD+VCR
Antenna
Antenna
OR OR
A
B
A
B
To view or record a CATV channel
Tune the TV to the DVD+VCR output channel
(CH 3 or 4).
Set the DVD+VCR channel selector to the cable
output channel. (Example: CH3)
Select a channel using the cable converter.
Notes:
With this connection, you cannot record one pro
-
gram while viewing another.
If you are using a cable box to tune channels, it is
not necessary to do Auto Channel Set.
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your TV.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable
(R).
How to set the DVD+VCR’s RF output
channel
When the DVD+VCR is turned off (standby
mode), press and hold CH (- / +) on the front panel
simultaneously for more than five seconds. “RF03”
or “RF04” appears in the display window.
Press CH (- / +) to change the RF output channel
(RF03 or RF04). Tune the TV to this channel.
Turn off the DVD+VCR.
Audio/Video connection
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using an
optional video cable
(V).
Connect the Left and Right DVD/VCR AUDIO
OUT jacks on the DVD+VCR to the audio left/right
in jacks on the TV
(A1) using an optional audio
cable.
Notes:
If you use this connection, set the TV’s source
selector to VIDEO.
For DVD/VCR VIDEO OUT jack connection,
resolution must be set to 480i or 480p, however
DVD/VCR VIDEO OUT is always at 480i standard
resolution.
1.
2.
3.
•
•
1.
2.
3.
1.
2.
•
•