Filter
Top Products
EN 49
INFORMATION ON J TERMINAL
J Terminal (JLIP (Joint Level
Interface Protocol) Connector)
The J Terminal is used to connect the recorder to a personal
computer or similar device to allow computerized control of the
recorder during editing and certain other operations.
Examples:
● Enables Random Assemble Editing of up to 99 segments with
the optional JLIP PLAYER PACK, using this recorder as the
playback unit.
● Allows you to capture still images from the recorder into a
personal computer with the optional JLIP VIDEO CAPTURE
BOX.
For further details consult your nearest JVC dealer.
JLIP ID Number
Your recorder has its own JLIP ID number. This ID number must
be unique when your recorder is connected to another device
via its J terminal. The ID Number is preset to "1" at the factory.
You can change this number to any number between "1" and
"99". If it is necessary to change the JLIP ID number perform the
following steps.
12
45
3
6
8
0
7
9
2
4
1
3
8
••
•
•
••
••
•
•
•
••
•
•
••
••
•
•
•
OK
MENU
PUSH JOG
ATTENTION
After you change your recorder's JLIP ID number, control
signal transmission may not work properly. If this happens,
turn off the recorder's power off once, then turn it back on
and try again.
ACCESS MAIN MENU
SCREEN
1
Press MENU twice.
ACCESS JLIP ID NO. SET
SCREEN
2
Press PUSH JOG %
fi
and
move the highlight bar
(pointer) to "JLIP ID NO.
SET", then press OK.
SET JLIP ID NUMBER
3
Press PUSH JOG
%
fi to
enter the desired ID
number.
RETURN TO NORMAL
SCREEN
4
Press MENU or OK.
JLIP ID NO. SET
1
CLOCK SET
[5∞] : SELECT
: OK
[MENU] : EXIT
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
GUIDE PROG SET
CLOCK SET
LANGUAGE SET
JLIP ID NO. SET
R.A. EDIT
[5
∞
] =
[MENU] : EXIT
J terminal