Filter
Top Products
16
LANGUAGE
Menu Language
Select a language for the VCR and DVD’s setup
menu and information display.
Disc Audio / Subtitle / Menu
Select the language you prefer for the audio track
(disc audio), subtitles, and the disc menu.
Original: Refers to the original language in which the
disc was recorded.
Other: To select another language, press number
buttons then ENTER (OK) to enter the corresponding
4-digit number according to the language code list in
the reference chapter (see page 33). If you enter the
wrong language code, press CLEAR (0000).
Off (for Disc Subtitle) : Turn off Subtitle.
DISPLAY
TV Aspect
4:3 :
Select when a standard 4:3 TV is connected.
16:9 : Select when a 16:9 wide TV is connected.
Display Mode
Display Mode setting works only when the TV Aspect
mode is set to “4:3”.
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide picture on
the entire screen and cuts off the portions that do not
fit.
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering.
If you are using the Component Video jacks for con-
nection to a TV or monitor that is compatible with a
progressive scan signal, set Progressive Scan to On.
To turn on progressive scan:
Connect component/progressive out of this unit to the
input of your monitor/television, set your television or
monitor to component/progressive Input.
1. Select “Progressive Scan” on the DISPLAY menu
then press B.
2. Select “On” using the v / V buttons.
3. Pressing ENTER/OK will set this unit to progres-
sive scan mode.
Note:
If you set Progressive Scan to ON in error, you must
reset the DVD+VCR. Press x (STOP) and hold it for
more then five seconds before releasing it. The video
output will be restored to the standard setting, and a
picture will once again be visible on a conventional
analog TV or monitor.