Filter
Top Products
Getting started
11
7
Assembling the satellite speakers (TH-A85 only)
Each speaker (except the center speaker) has been divided into two
parts for shipment. Before connecting the satellite speakers, first
assemble them by following the procedure below.
Before assembling —
• Prepare a Phillips screwdriver.
• Take care not to drop the stand while assembling; otherwise, it
may cause damage to the floor or injury.
• Ensure enough space exists for assembly and installation.
• Spread a large, thick cloth on the floor where you assemble the
speakers, so you can protect the floor and the speaker itself.
1
Connect the speaker connectors to the
stand connectors.
• Be sure to connect the speaker connectors by matching their
sizes.
2
Join the stand to the speaker section.
3
Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Repeat the procedure from step 1 to assemble the other satellite
speakers.
NOTE
• Use the speaker after assembly is fully and correctly done.
• It is recommended to place a cushion under the speaker section.
You can tighten the screws easily by placing the speaker section
horizontally.
Stand
Speaker section
Speaker connectors
Front
Front
Rear
Stand
Speaker section
Stand
Speaker section
Speaker section
Stand
Screws (4)
(supplied,
M4 x 25 mm)
Cushion
(not supplied)
This page is for
TH-A85
TH-A85-55[B].book Page 11 Friday, March 28, 2003 12:01 PM