JVC XV-521 DVD Player User Manual


  Open as PDF
of 1
 
JVC Upgrade Tool Solderless Upgrade Instructions
First you must get the player ready to accept the upgrade tool, this process
differs from one model another.
XV-521 / 522 / 523 , XV-M567 , XV-S40 / 42 , XV-E100 / 112 , XV-S300 / 302
Plug the player in whilst holding the “Play” and “Open/Close” keys on the front panel
, the front panel display will show “Test E2” on a R2 player.
TH-A9 / 10 , TH-M45 / TH-M65 / TH-V70 , TH-A55 / 75 / 85
Plug the player in whilst holding the “Stop” and “Eject” keys on the player , the
display will show “Test” ( if not then use “Power” and “>>|” instead )
TH-S1 / S3 / S5 / S7 / S8 / SW8 / S9 / SW9 / S51, TH-M303 / TH-M603
Plug the player in whilst holding the “Power” and “Play” keys on the player , the
display will show “Test” ( if not then use “Pause” and “Play” instead )
XV-NP1 / XV-C5 / XV-N5 / XV-N30 / XV-N33 / XV-N35 / XV-N40 / XV-N44 /
XV-N55 / XV-NA77 / XV-N412 / XV-N512
Turn on the player in whilst holding the “|<<” and “>>|” keys on the player , the
display of the player will come up with the current region (REG x) or (REGION x)
RX-DV3 / RX-DV31
Turn on the player in whilst holding the “Stop” and “DVD” keys on the player , the
display will show “Test”
Now you are ready to perform the upgrade …. Insert the upgrade tool into either
of the “Compulink” sockets on your DVD player and press the button on the tool
( a few seconds only ) until you see the following confirmation signals from the
player.
XV-521 / 522 / 523 and XV-M567 will show “V.Mask”
XV-S40 / 42 , XV-E100 , XV-S300 / 302 will show “D.Mix” ( Sometimes D.Mix
will not show )
TH-A9 / 10 , TH-V70 , TH-A55 / 75 / 85 , XV-NP1 ,TH-S1 / S3 / S5 / S7 / S8 /
SW8 / S9 / SW9 / S51 , TH-M45 / TH-M65 / TH-M303 / TH-M603 / RX-DV3 /
RX-DV31 will show “Change OK” , “Region 0” or “Info”
XV-C5 / XV-N5 / XV-N30 / XV-N33 / / XV-N35 / XV-N40 / XV-N44 / XV-N55 /
XV-NA77 / XV-N412 / XV-N512 display will change from REG x to REG 0.
Finally remove the tool , switch off then unplug the player … when you plug it
back in it will be Multiregion.