Filter
Top Products
135
6 Connect the cable to the hard disk.
Connect the 40 pin flat cable and power supply
cable (attached to the hard disk cartridge) to the
hard disk. Be careful that the connectors are ori-
ented correctly, and that they are pushed in all the
way.
7 Fasten the hard disk in the hard disk cartridge.
Use the screws included with the hard disk to fas-
ten the hard disk in place.
8 Insert the hard disk cartridge into the D1600.
Push it firmly in all the way.
9 Using the screws that you removed in step 4, fas-
ten the hard disk cartridge to the D1600.
0 Close the front cover.
Attach the front cover that you removed in step 2.
Raise the lock levers located at the left and right of
the D1600 to lock the front cover in place.
Checking the operation of the hard disk
1 Use the procedure described in “Turning the
power on” to turn on the power, and verify that
the D1600 starts up correctly.
If the D1600 fails to start up correctly, re-check the
installation.
2 If a message of “INIT Internal Hard Disk Drive”
appears when you turn on the power, press the
“OK” button to initialize the hard disk.
When you execute the Initialize operation, all data
that had been recorded on that hard disk will be
erased.
3 Once initialization is completed, you are ready to
use the D1600.
If errors such as “Disk” or “DiskBusy” appear fre-
quently during operation, execute the Format oper-
ation. (→p.79)
Appendices
About the drive