Kramer Electronics T1AF-26 TV Cables User Manual


 
The Kramer T1AF-26 Inner Frame
Congratulations on purchasing your Kramer T1AF-26 inner frame for the TBUS-1Axl Table
Connection bus.
The T1AF-26 inner frame includes:
An opening for 2 power sockets 2 cable pass-through inserts
4 blank inserts
Figure 1: T1AF-26 Inner Frame (P/N: 80-000399)
Power Socket and Power Cord Options
Various power sockets and power cords are available to use with the T1AF-26, as described
in the “TBUS Modular Power Socket Installation and Power CordInstallation Instructions,
supplied with the power socket.
i
Each power socket comes with detailed assembly instructions.
Mounting the Inserts
i
Go to http://www.kramerelectronics.com to check for up-to-date
user manuals and the complete list of Kramer wall plates and
module connectors.
You can rearrange or remove any of the plates mounted on the inner frame and replace them
with Kramer passive wall plates or connector modules for interfacing A/V type signals.
To mount a Kramer insert or connector module:
1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the
blank plate.
2. Place the required Kramer insert over the opening, insert the two screws to fix the
Kramer insert in place, and tighten them.
Installing the Assembled Inner Frame
To install the T1AF-26 inner frame:
1. Place the assembled inner frame inside the TBUS-1Axl enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired
position, screw and tighten it in place using the height adjustment screws supplied with
the inner frame.
Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so
on):
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the TBUS-1Axl.
Do not secure the cables too tightly or too loosely. Leave a small amount of slack.
After the TBUS-1Axl is connected to mains power and the proper cables, it is ready for use.
Inserting Pass-through Cables
To insert the pass-through cables (for example, to connect a laptop) do the following:
1. Remove the four screws attaching the split pass-through bracket.
2. Remove the split grommet(s).
3. Insert the cable(s) through the rectangular opening.
4. Open the split grommet slightly and insert the required cables.
5. Place the split bracket around the grommet and position this assembly over the inner
frame.
6. Place the four screws appropriately and tighten the split bracket together with the
grommet and inserted cables to the inner frame.