Filter
Top Products
22
[LOCK] Menu (Parental Control)
Password
You can enter or change the password.
1. Select [Password] option on the [LOCK] menu
then press B.
2. To create new password, press ENTER when the
[New] option is highlighted. Input new password
and press ENTER. Enter it again and press
ENTER to verify.
To change the password, press ENTER when the
[Change] option is highlighted, then input old
password and press ENTER. Input new password
and press ENTER. Enter it again and press
ENTER to verify.
To delete the password, select [Delete] option
then press ENTER, then input old password and
press ENTER. The password is deleted.
Tip:
If you make a mistake before pressing ENTER,
press CLEAR. Then input the correct password.
If you forget your password
If you forget your password, you can clear it using
the following steps:
1. Remove any disc that might be in the player.
2. Select [Password] option.
3. Use Number buttons to enter the 6-digit number
“210499”.
The “PIN CLEAR” appears in the display window
and the password is deleted.
Rating
Blocks playback of rated disc based on their con-
tent. (Not all discs are rated.)
1. Select [Rating] on the [LOCK] menu then
press B.
2. To access this option, you must input the pass-
word you have created. If you have not yet
entered password, you will be prompted to do so.
Input a password and press ENTER. Enter it
again and press ENTER to verify. If you make a
mistake before pressing ENTER, press CLEAR.
3. Select a rating from 1 to 8 using the v / V but-
tons.
[Rating 1-8] – Rating one (1) has the most
restrictions and rating eight (8) is the least
restrictive.
[Unlock] – If you select unlock, parental control
is not active and the disc plays in full.
4. Press ENTER to confirm your rating selection.
BD Age
Set an age limit of BD-ROM play.
1. Select [BD Age] on the [LOCK] menu then
press B.
2. Follow step 2 as shown above (Rating).
3. Use number buttons to input an age limit for
BD-ROM viewing.
[255] – All BD-ROM can be played.
[0-254] – Prohibits play of BD-ROM with corre-
sponding ratings recorded on them.
4. Press ENTER to confirm your selection.
Area Code
Enter the code of the area whose standards were
used to rate the DVD video disc, based on the list
on page 33.
1. Select [Area Code] on the [LOCK] menu then
press B.
2. Follow step 2 as shown above (Rating).
3. Select the first character using v / V buttons
then press ENTER.
4. Select the second character using v / V buttons
then press ENTER to confirm your selection.
BH200-N_AUSALLK_OM_ENG 10/18/07 3:03 PM Page 22