Black RF
coaxial cable
(supplied)
Antenna or
Cable TV
signal
Antenna In Jack
(on back of TV)
example only
1
2
8
Hookups (cont’d)
1
Disconnect the antenna or Cable TV signal from your TV and connect it to the ANT-IN
(Antenna In) jack of your DVD/VCR.
2
Connect the supplied black RF coaxial cable to the ANT-OUT (Antenna Out) jack on the
back of the DVD/VCR and to the ANTENNA IN JACK on the TV.
The ANTENNA IN jack on
the TV may be labelled TV IN, RF IN, 75Ω (ohm), or ANT-IN. See your TV owner’s manual for assistance.
3
Plug in the power cords of the TV and the DVD/VCR.
4
Set your TV to channel 3 or 4. The DVD/VCR’s output channel is 3 when you purchase it. So, set
your TV to channel 3 when the DVD/VCR is new.
If you cannot use channel 3 at your TV, you can change the DVD/VCR’s output channel to channel 4.To
do so, press the VCR button to put the DVD/VCR in VCR mode.The VCR light will be on the front of
the DVD/VCR. Insert a videotape and press PLAY
B to start playback. During playback, press and
hold the (VCR) PLAY B button on the front of the DVD/VCR for three to five seconds.
Each time you do this, the DVD/VCR’s output channel switches between 3 and 4, and the selected chan-
nel number appears on the front display. Change your TV to channel 3 or 4 accordingly. (You cannot
change the DVD/VCR’s output channel while adjusting tracking manually. Press STOP
C to stop playing
and cancel manual tracking, then press PLAY
B to resume playing and change the output channel.)
There is not a channel 3/4 switch on the DVD/VCR (as customary with most VCRs).
5
You are ready to turn on the DVD/VCR. Go to page 17 before turning on the DVD/VCR.
DVD/VCR to TV only
Simplest connection using only the supplied black RF coaxial cable
This connection will let you use the features of both the VCR and the DVD Player.
