Metrologic Instruments MX009 Cable Box User Manual


 
3
INTRODUCTION (CONT.)
HOW IS THE MX009 CONFIGURED FOR USB SERIAL EMULATION?
This guide contains the configuration bar codes necessary to ensure that the
scanner communicates properly with the MX009. The scanner
communicates using RS232 protocol. The default (RS232) settings of the
scanner are as follows:
For Non-PowerLink Scanners
9600 baud, 7 data bits, 2 stop bits and space parity
For PowerLink Scanners
9600 baud, 8 data bits, 1 stop bits and no parity
In addition, the scanner uses ACK/NAK and XON/XOFF software
handshaking, and the data transmission ends with both carriage return and
line feed suffixes.
NOTE #2
When using USB Serial, special prefixes are not required.