Filter
Top Products
70 6. NetCommand Control of an A/V Receiver (838 Series)
For assistance call 1(800) 332-2119
Automatic Audio/Video Switching Over an
HDMI Connection
If your A/V receiver has an HDMI output, it may be
convenient to send video to the TV over a single HDMI
cable through the A/V receiver. The following setup
enables the A/V receiver to switch automatically to the
correct input when you select a device in the TV’s Input
Selection menu. Depending on the capabilities of the
A/V receiver, the connected source devices can be
analog, digital, or a mixture or the two.
VCR with
Analog Audio Output
A/V Receiver
HDMI
Output
HDMI
Cable
Connections of
any type
Blu-ray player
DVD player
Cable box
VCR
TV
Use NetCommand to switch an A/V receiver
automatically to the correct audio and video inputs for
a device (available only with an HDMI output to the TV
as shown).
Setting Up A/V Receiver Control, continued
More About Using an HDMI Connection
Audio from devices connected directly to the •
TV can be heard from the TV speakers only.
To send audio to the A/V receiver from such
devices, use one of the optional audio con-
nections shown in the diagram on the oppo-
site page. For example, use an optional audio
connection if you wish to use the A/V receiver
speakers to hear audio from:
The -
ANT
input
A game or camcorder connected directly -
to the TV.
To use NetCommand to supplement HDMI •
control of a CEC-enabled A/V receiver, the
recommended setup sequence is:
Connect the HDMI cable.1.
Enable HDMI control (2. New Device Found
screen).
Connect the secondary digital audio 3.
cable, if desired.
Perform NetCommand setup.4.
If you perform A/V receiver NetCommand
setup first and then later connect an HDMI
cable, the NetCommand setup will be lost.
In some cases, audio from a device connected •
to the A/V receiver may not be passed over the
HDMI cable to the TV speakers. In these cases
you must use the A/V receiver speakers to hear
audio.
Downloaded From TV-Manual.com Manuals