Filter
Top Products
4. TV Menus 55
For assistance call 1(800) 332-2119
Setup, continued
Setup Channel
Ant Air,
Ant Cable
You must perform a channel scan to receive digital channels. The scan searches for broad-
cast channels and adds them to TV memory. To start channel scan:
Highlight one of the input selections based on your connection to the1.
ANT input
:
Air• when connected to an indoor or outdoor antenna.
Cable• when connected to direct cable (no cable box)
Select the scan type.2.
Select • All Channels for an initial scan or after moving the TV to an new area with a differ-
ent channel line-up.
Select • New Only to search for channels newly broadcasting since the previous scan.
Press 3. to highlight SCAN.
Press 4.
ENTER
to start channel memorization.
See below for additional notes on Scan.
All Channels,
New Only
Scan
Edit After channel scan, Edit lets you add and delete memorized channels. Memorized channels are
those you can tune using the
CH
key. Edit the channel list to limit tuning to channels you watch.
• Press
CH/PAGE
to jump to the next or previous page of channel numbers.
• Press to move through all channel numbers, one at a time.
Adding/Deleting Channels Using the Channel Edit
Menu
Channels marked with a check are in memory.•
To add or delete a channel from • memory, highlight
the channel number and press
ENTER
.
To add a single digital channel not in the list, see •
the notes under Scan on this page.
Digital channels are listed by virtual channel •
number with the physical channel number shown in
small gray text.
Virtual - Channel Number (digital channels
only). A channel number sent by a local broad-
caster.
Physical Digital Channel Number. - The
channel number officially assigned to the actual
broadcast frequency; shown on screen in gray
text.
Notes on Scan and Channel Memorization
• Channelmemorizationmaytakeupto15minutesto
complete.
•
To stop channel memorization before completion, press
CANCEL
.
Channels already added are retained
.
• WhenwatchingTV,press
CH
to move through
memorized channels. Press and hold
CH
to speed
through channels.
•
To add a digital channel that does not appear in the
Edit menu without performing channel memorization:
Look up the 1. physical channel number for
the new digital channel. See the website
www.antennaweb.org for help.
Press 2.
INPUT
and select the
ANT
input.
Use the number and 3.
CANCEL
keys to enter the
physical channel number followed by “-1” and
ENTER
. For example, for physical channel 36,
3
6
1
ENTER
.
The TV will search for a digital channel on the channel
36 frequency. When it finds the channel, it will:
a. Add the channel to memory.
b. Change the channel number to the virtual
channel number sent by the broadcaster.
c. Add to memory any associated sub-chan-
nels.
Rememorize channels if you move the TV to a different •
geographic area with a different channel line-up.
Downloaded From TV-Manual.com Manuals