One for All URC-2585 Universal Remote User Manual


 
Helpful Hints
16
Trouble-Shooting
Problem:
Red light does not
blink when you press
a key?
The ONE FOR ALL
does not respond
after pressing a key?
The ONE FOR ALL
does not operate your
device(s)?
Your brand is not
listed in the ONE FOR
ALL code section?
When following the
set-up instructions,
the red light on the
ONE FOR ALL only
blinks once instead of
twice after you enter
a three-digit code?
The ONE FOR ALL is
not preforming
commands properly?
Press a key but get
the wrong result?
You cannot control
the volume feature of
your Satellite, Cable
Converter or TV/
Video combination or
you cannot control
the volume of your
TV set up on the AUX
key?
Problems changing
channels?
Video not recording?
Scan does not work
on your device?
Solution:
Replace batteries with 4 fresh, new
AAA alkaline batteries.
Make sure you are using new
batteries and are aiming the ONE
FOR ALL at your device.
A) Try all the codes listed for your
brand.
B) Try the search method on page
14.
Try the search method on page 14.
Did you use the Code Lock feature?
You must first unlock the code
before entering a new code. Follow
the instructions on page 13 to do
this.
You may be using the wrong code.
Start the search method over again
to locate the proper code.
Hold MAGIC until the red light
blinks twice, then press 992 and the
device key twice. You will need to
set-up your device again. Try the
codes for your brand or the search
method on page 14.
Hold MAGIC until red light blinks
twice. Then press 993 and VOL+. To
set the volume control back to TV
(Punch Through), hold Magic until
the red light blinks twice, then
press 993 TV.
Enter the programme number
exactly as you would on your
original remote.
As a safety feature on your ONE
FOR ALL, you must press the Record
key twice.
Make sure your original remote had
a programme +/- key.