One for All URC-7540 Universal Remote User Manual


 
25
Sleeptimer
Sleeptimer is a feature which comes built into many TVs and
Satellites. It allows you to set your device to turn off within a
certain amount of time. This feature comes in handy if, for
example, you enjoy falling asleep with your television on.
With the ONE FOR ALL, there are two ways to use the
sleeptimer. If your TV or Satellite came with this feature built
in, follow the instructions “Device Sleeptimer” below. If your
device did not come with this feature, follow the instructions
“ONE FOR ALL Sleeptimer”
Device Sleeptimer
If your TV or Satellite has a “Sleeptimer” function built in, you
can access this function with your ONE FOR ALL remote. To do so:
Make sure your TV (or Satellite) is switched on.
Press the device key (TV or SAT).
Point the ONE FOR ALL at your TV (or
Satellite) and press and release MAGIC
then press POWER. You should see the
Sleeptimer activate on your TV screen.
To increase the timer, simply press
POWER again (within 5 seconds) until the
timer gets to the desired time.
To deactivate the Sleeptimer, repeat steps 1-3 above. During
step 3, continue pressing Power until the timer indicates zero
minutes.
Advanced Features
Important note: Remember, your device must have its own
Sleeptimer function in order for the above instructions to operate.
If your device does not have its own Sleeptimer, follow the
instructions outlined on the next page.
1
2
3
or