Filter
Top Products
20
2. While holding down
TV
, enter the code
number for your TV using the number but-
tons Or, while holding down
DSS/CABLE
,
enter the code number for your cable box
or direct-to-home satellite receiver.
Precede a single-digit code number with a
0 — for example, 01, 02, and so on. To
enter a three-digit number, press
100
, then
enter the second and third digits in the
code number.
3. Try operating your TV and cable box or
direct-to-home satellite receiver using the
VCR’s remote control. First press
TV
or
DSS/CABLE
, then try pressing
POWER
,
INPUT
,
CH
s or
CH
t, and
VOL +/–
for TV
operation; or
POWER
and
CH
s or
CH
t for
cable box or direct-to-home satellite
receiver operation.
If the device does not function, repeat Step
2 and try other codes for the manufacturer.
If it still does not function, you must use the
original remote control supplied with your
TV and cable box or direct-to-home satel-
lite receiver.
To use the remote control, press the button for
the device you want to control—
TV
,
DSS/CABLE
,
or
VCR
. Then press the desired function button.
Notes:
• The codes you programmed might be
erased if you remove the batteries from the
remote control (to replace them, for exam-
ple). If this happens, re-enter the codes
after you replace the batteries.
• Some TVs, cable boxes, and direct-to-
home satellite receivers might require that
you manually turn on the power for that
device.
• Your TV, cable box, or direct-to-home sat-
ellite receiver might have functions that the
VCR’s remote control will not operate.
• You can use the number buttons to select a
channel number on your TV and cable box
or direct-to-home satellite receiver. How-
ever, some TVs and cable boxes or direct-
to-home satellite receivers might require
that you press
DISP/ENT
after entering the
channel number.
•
VOL +/–
works to adjust the TV volume in
any operation mode (VCR, TV, or DSS/
CABLE).
• When you press
TV
or
DSS/CABLE
then
press
MENU/ACTION
or
PROG
,
NOW
TV/
CABLE/DSS
MODE
PLEASE
PUSH
VCR
KEY
ON
REMOTE
appears, and TV or
CAbL
flash for about 5 seconds then dis-
appear. Press
VCR
to set the remote con-
trol to VCR operation mode.
16-634.fm Page 20 Tuesday, July 20, 1999 5:37 PM