Filter
Top Products
– 12 –
AC IN connector
This is for connecting the unit to the power outlet using the power cord provided.
SIGNAL GND terminal
This terminal is connected to the signa unit which is connected to the unit in order to
reduce noise. It is not connected to ground for safety purposes.
Fuse holder
This contains a fuse.
Fan motor
This is for cooling the unit.
The error code is displayed on the counter when trouble has caused the fan motor to
stop. If the unit is still operated in the warning status, the temperature inside the deck will
rise, and when it exceeds the safety temperature, all the unit’s operations will be shut
down.
ANALOG AUDIO IN connectors*
These are the analog audio input connectors.
TIME CODE IN connector*
This is the connector for recording the external time code on the tape.
S1-VIDEO IN connector*
This is the S-VIDEO input connector.
ANALOG COMPONENT VIDEO IN connector*
The analog component video signal is supplied to this connector.
ANALOG COMPOSITE VIDEO IN connectors and 75Ω termination switch*
The analog composite video signal is supplied to these two connectors which are
connected in a loop-through configuration. When the termination is required, set the
switch to ON.
REF VIDEO IN connectors and 75Ω termination switch
These are the input connectors for the reference video signals. When the termination is
required, set the switch to ON.
ANALOG AUDIO OUT connectors
The analog audio signals are output from these connectors.
TIME CODE OUT connector
The playback time code is output from this connector during playback.
During recording, the time code generated by the internal time code generator is output.
MONITOR OUT connector
The playback signals from the CUE track or PCM audio signal CH1/CH2 are output from
this connector.
<Connector area>
q
w
e
r
t
y
u
i
o
!0
!1
!2
!3
Controls and their functions (continued)
* Applicable only to
AJ-D450.