Panasonic AJ-D440 VCR User Manual


 
– 33 –
The underline on the setting item denotes the initial setting.
* The Setup menu can only be displayed for the model AJ-D450.
Item Setting
No.
Superimposed
display
Description
No.
Superimposed
display
USER menu
<OPERATION> (continued)
112 AUTO REW 0000
0001
OFF
ON
This selects whether to rewind the tape automatically to the
tape start when the tape end is detected.
0:
1:
The tape stops at the tape end.
The tape is rewound to the tape start.
113 MEMORY
STOP
0000
0001
OFF
ON
This selects whether the VTR is to stop automatically when
the counter value reaches “0” during a fast forwarding or
rewinding operation in the CTL mode.
0:
1:
<Notes>
1.
2.
The VTR does not stop.
The VTR stops automatically.
The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 313 (AFTER CUE-UP) setting.
When both the AUTO REW function and MEMORY
function have been selected at the same time, the AUTO
REW function takes precedence.
109* EJECT EE
SEL
0000
0001
EE
BLACK
This selects whether EE mode or BLACK is to be used during
EJECT status.
0:
1:
EE mode
Video blackens, audio mutes.
110* F/R EE SEL 0000
0001
EE
TAPE
This selects whether EE mode or playback mode is to be
used during FF/REW operations.
0:
1:
EE mode
Playback mode
111* STOP EE
SEL
0000
0001
EE
TAPE
This selects whether EE mode or playback mode is to be
used during stop mode.
0:
1:
<Note>
The STAND-BY OFF mode complies with the above selection.
When TAPE is selected, however, the video becomes grey.
EE mode
Playback mode
114* REC
INHIBIT
0000
0001
OFF
ON
This selects whether to allow (enable) or prohibit (disable) the
recording of signals on the cassette tape.
0:
1:
Signals can be recorded on the cassette tape when the
cassette’s accidental erasure prevention mechanism is
set to the recording enable position.
Recording on the cassette tape is prohibited. In this case,
the REC INH lamp on the front panel lights.
115 STOP
RESPNS
0000
0001
NORMAL
QUICK
This selects the response when the mode is changed to
STOP/STILL while the tape is traveling.
0:
1:
<Notes>
Priority is given to the output picture.
Priority is given to the response.
At the 1 (QUICK) setting, the picture may not be as clear in
the STOP/STILL mode as it would be at the 0 (NORMAL)
setting.
CTL may shift by ±2 frames.