Filter
Top Products
– 73 –
USER menu
<AUDIO> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
713 MONI CH 0000 MANU
SEL 0001 AUTO1
0002 AUTO2
714 REC CH1 0000 CH1
0001 CH2
0002 CH1+2
715 REC CH2 0000 CH1
0001 CH2
0002 CH1+2
716 REC CUE 0000 CUE
0001 CH1
0002 CH2
0003 CH1+2
718 DV 0000 ST1
OUTPUT 0001 ST2
0002 ST1+2
719 PB FADE 0000 AUTO
0001 CUT
0002 FADE
720 EMBEDDED 0000 OFF
AUD
0001 ON
722 INT SG 0000 OFF
0001 ON
The underline on the setting item denotes the initial setting.
This selects the monitor output.
0: The output is as selected in MONITOR SELECT.
1: The output defaults to CUE except when speed factor is
between –0.43× and 1×, inclusive, in which case output is
PCM AUDIO.
2: The output defaults to CUE except in PLAY mode, in which
case output is PCM AUDIO.
<Note>
These menu settings are valid when CH1 or CH2 has been
selected by the MONITOR SELECT L/R switches on the front
panel. (When CUE has been selected, the CUE signal will be
output at all speeds regardless of the above menu setting.)
This selects the input signal to be recorded on the audio CH1
track.
0: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.
This selects the input signal to be recorded on the audio CH2
track.
0: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.
This selects the input signal recorded in CUE.
0: CUE input
1: The signal selected in Setup Menu No. 714 is recorded.
2: The signal selected in Setup Menu No. 715 is recorded.
3: A mixed signal of the signals selected in Setup Menu No.
714 and Setup Menu No. 715 is recorded.
This selects the AUDIO CH1 and CH2 output signals during
DV or DVCAM format playback.
0: The CH1 track signals are output to CH1 and the CH2 track
signals to CH2.
1: The CH3 track signals are output to CH1 and the CH4 track
signals to CH2.
2: The mixed CH1 and CH3 track signals are output to CH1
and the mixed CH2 and CH4 track signals to CH2.
<Note>
This item setting is valid only when the tape recorded on the
four channels of the DV or DVCAM format is played back.
This selects the processing method for the audio edit points
(IN point, OUT point) during playback.
0: According to the status during recording.
1: Forced CUT
2: Forced FADE
This selects whether to superimpose the audio data onto the
serial output.
0: Data is not superimposed.
1: Data is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.
This selects whether to use the internal signals as the audio
input signals.
0: The internal signals are not selected.
1: The internal signals are selected.
<Note>
The internal signals have a frequency of 1 kHz.